오븐 온도 테스터는 주로 사용되는 오븐 온도 테스터 분야에서 최신 세대의 유연한 작동과 정확한 측정입니다.리플로우오븐 and 웨이브 납땜 machine. It can measure the temperature of the PCB over the oven, in order to prepare for the development of the appropriate soldering temperature.
1. the pyrometer with the external PCB cable is connected according to the plug number, while preparing the gloves and tester heat insulation box.
2. the pyrometer connected to the computer through the data cable, lightly press the "MODE" key on the pyrometer, so that the "Status" red light flashes slowly.
3. with the left mouse button in turn click the tester supporting application window "Connection change" and connection application" to clear the temperature data stored in the tester, to determine the "computer" window shows the thermometer power greater than 60 percent .
4. disconnect the pyrometer from the computer, before reflow oven, put the pyrometer into the thermal barrier, lightly press the "MODE" button, see the "Status" red light is flashing, quickly close the thermal barrier cover, and external PCB and thermal barrier cover together on the reflow oven stencil, so that the PCB and thermal barrier to keep at least ten centimeters and the thermal barrier to maintain a distance of at least ten centimeters.
5. After waiting for the PCB and thermal barrier to come out of the oven at the end of the reflow oven, quickly open the thermal barrier cover and lightly press the "MODE" key to make the "Status" red light resume slow flashing, at this time the oven temperature meter has stopped reading data and the oven temperature data has been stored in its memory. in the memory.
6. 고온계에서 컴퓨터로 온도 데이터를 다운로드하고, 온도 곡선의 합리성을 분석하고, 가능한 경우 인쇄하고, 그렇지 않은 경우 시간에 로 온도를 조정합니다.
1. First of all, check whether the battery power is sufficient, if it is less than 20 percent , it must be charged first, secondly, if the surface temperature of the instrument is higher than 45 degree , please do not charge, try to charge at room temperature.
2. thermocouple probe is generally small, must be fixed in the test position with the specified high temperature solder or adhesive, otherwise heat loosening, deviating from the intended test point, causing test errors.
3. The thermal barrier can withstand temperature at 280 degree for 9 minutes at most, please be sure to exceed this range to ensure that the internal temperature of the instrument does not exceed 85 degree .
4. Please observe whether the data indicator flashes every 5 seconds for a long time, if it flashes, please press and hold the "start" and "end" keys at the same time for about 5 seconds until the indicator flashes suddenly, then observe until there is no light flashing.
5. Be sure to cover the thermal barrier when you pass the oven, and hear the "click" sound as well.
6. Only one oven temperature tester can be connected to the computer at a time. You cannot connect multiple recorders to different USB ports on the computer at the same time and then choose one of them.
7. after a furnace again, wait for the thermal barrier to cool before using.
오븐 온도 테스터는 PCB 보드의 온도를 퍼니스로 모니터링하고 각 온도 영역의 온도 변화를 기록하고 모니터링 데이터가 정확할수록 PCB 보드에 대한 용접 효과가 더 좋습니다.
